Numerical Investigation of Hybrid Pin-Finned Heat Sinks filled with Phase Change Material for Optimized Thermal Performance in Mobile Electronics
Main Article Content
Abstract
A parametric and statistical analysis of a hybrid PCM–pin-finned heat sink under steady heat flux cooling for mobile electronic applications: A numerical study Latent heat storage using paraffin wax as phase change material (PCM) is considered, and heat transfer augmentation is achieved using aluminum circular pin fins. CFD transient analyses are performed with the enthalpy–porosity method to investigate the combined influence of PCM volumetric fraction, pin-fin diameter and applied heat flux density on thermal performances. The results show that the PCM integration decreases the peak temperature by 10–12% and delays the onset of heating by 15–20% in comparison with non-PCM configuration, illustrating efficient thermal buffering. Increasing the heat flux from 1500 W/m² to 3500 W/m² reduces of the order of 35– 50% the duration time associated with the absorption of latent heat and surface peaking temperature by up to about 20%, which shows the shift, in strong dependence with FL. Et 12 The pin-fin size has a strong impact on the phase change dynamics— the increase in diameter improves PCM melting rate by 20–22% at mid-melting conditions, since the total heat transfer area increases. Nevertheless, beyond the optimum diameter of about 3 mm, additional thermal resistance is imposed whereby the heat capacity and thermal conductance decrease by 10–12%. Optimized finds can have a maximum heat capacity of about 3.5 kJ/K and increase the thermal conductance by around 30% compared to those with no fin. Analysis indicates convective resistance controlled - An experimental verification of above result shows that thermal enhancement is determined by a balance of the conductive surface increase and convective resistance. The statistically determined results supply design guidelines that can be physically interpreted for manufacturable, high performance PCM-based heat sink for compact and mobile electronics.